Damp proofing and wall waterproofing
Rising damp, wet basements, leaking walls and mould, diagnosed with moisture readings and fixed at the source with Köster systems.

Is it rising damp, a leak or condensation?
Rising damp shows as tide marks, bubbling plaster, salt deposits and a musty smell at the bottom of a wall. It happens when the damp-proof course is missing, bridged or failed, and ground moisture wicks up through the brickwork.
Leaks, condensation and rain driven through the wall look similar but need a different fix. That is why we start with moisture readings at the free assessment.
How do you treat rising damp?
We install a new horizontal damp barrier inside the wall with Köster Crisin 76, a solvent-free resin fed into the wall without pressure. It works in very wet, salt-laden walls.
- Confirm the cause with moisture readings.
- Remove salt-damaged plaster.
- Drill the lowest horizontal joint and insert the injection cartridges for about 7 days.
- Seal the holes and re-plaster with a salt-resistant render.
What other wall work do you do?
Wall and façade waterproofing
Keeps wind-driven rain out of exposed walls, window frames and parapets.
Basements, tanks and lift pits
Below-ground walls and floors sealed with Köster NB 1 Grey, often from the inside.
Damp and mould treatment
We treat the mould and fix where the moisture comes from, so it does not come back.
Wall crack repair
Moving cracks are repaired with flexible systems, not rigid filler that cracks again.
Expansion and movement joints
Façade, slab, panel and frame joints sealed with Köster MS Joint Sealant.
Wall coatings and painting
Exterior and interior coatings for homes, complexes, boundary walls and commercial buildings.
Where do you do damp proofing?
Nationwide, with teams in Gauteng, the Western Cape and KwaZulu-Natal. Local advice for Johannesburg, Pretoria, Cape Town and Durban.
Questions we get asked
How do you know it is rising damp?
We take moisture readings to confirm it is rising damp and not a leak, condensation or damp coming through the wall from outside, before anything is installed.
Does the wall have to dry out first?
No. Köster Crisin 76 works however wet the wall is and whatever the salt load, so the wall does not need to be dried first.
How long does rising damp treatment take?
The injection cartridges stay in the wall for about 7 days. Then the holes are sealed and the plaster is restored with a salt-resistant render.
Can you treat the wall from one side only?
Yes. The holes can be drilled from the inside or the outside.
Will painting over damp or mould fix it?
No. Paint hides the problem for a few months. The moisture source has to be stopped first, then the wall can be restored and coated.
Get a free damp assessment
Tell us what is happening and where. We will arrange a site visit and send you a written proposal – no obligation.